PLANET WRT-416 - Manual (Page 9)

LED STATE MEANING
On Power is on SYS
Flashing The device is working
On WAN link is on
Flashing WAN activity
WAN
Off No connection
On Link is established
Flashing Packets are transmitting or receiving
LAN 1~4
Off No connection
2.4 Back View
z Power (DC 9V): The power socket is where you plug in the power adapter. Please use the power
adapter provided with this wireless broadband router.
z
LAN 1- 4: These 4 ports are used to connect the router to your PCs using Ethernet cables. Any of these
four ports can also serve as an uplink port to other network devices, such as another router or switch,
which allows you to extend your network.
z
WAN: Connect your modem to your router using this port with your supplied Ethernet cable. This is the
only port you can use for this procedure. This enables your router to access the Internet. The port
supports 10/100 Mbps as well as straight-through and crossover Ethernet cables.
z
Default button: Reset the router to factory default settings (clear all settings) or reboot the router
function.
1. Set to factory defaults: Press this button and hold for over 5 seconds to restore all settings to
factory defaults,
2. Reboot the router: Press this button for less than 5 seconds to reboot.
z
Antenna: The antenna used for wireless connections. You are able to rotate the antenna to gain the
best signal reception.