Sony ZV-1F Vlogging Camera (Black) User Manual
Page 148
148
1) “Media(B)” for the card in slot B.
Copy All Sub Clips
NG: Reached Clip Number Limit
NG: Same File Already Exists
NG: Not Enough Capacity
Copying of all sub-clips using Copy All Sub Clips failed because of the
displayed reason.
• The maximum number of clips is reached.
• There is a file with the same name.
• There is not enough capacity for copying.
Replace the media.
Invalid setting value was reset:
Media/Clip Naming/Camera Position
Please save All File again
The Clip Naming format setting was reset because an invalid ALL file
was loaded.
Configure the desired format settings, and try to save the ALL file again.
The specified address is invalid.
The specified address is invalid.
Check that the setting is correct.
Cannot Use Specified Port Number
The specified port number is invalid.
Check that the setting is correct.
Failed
This error may appear if an address cannot be obtained with DHCP set to
On.
Check the DHCP server settings.
Cannot add auto upload job of Proxy file
because maximum number of upload jobs
was reached.
The maximum number of transfer jobs has been reached.
Clear any unwanted jobs. The auto upload destination setting for proxy
files may also be incorrect. Check that the setting is correct.
<SSID>Not found.
Network (access point) with the specified <SSID> could not be found.
Check that the setting is correct.
<SSID>Authentication Failed
Connection authentication on the network (access point) with the
specified <SSID> failed.
Check that the password and other settings are correct.
An IP address conflict has occurred. Please
check the network settings.
There is a conflict in the network addresses of the wireless LAN, wired
LAN, modem, or between modems.
Change the address manually or change the settings for the network
router.
The IP address of the Wireless LAN Access
Point Mode has been changed due to an IP
address conflict.
The IP address of the wireless LAN access point mode was changed due
to a conflict in the network addresses of the wireless LAN access point
mode, wired LAN, or modem.
Check the IP address setting.
Display message
Cause and Solution