Canon DP-V2421 4K Reference Display - Manual (Page 88)

88 OSD Menu
Item Setting Options (underline indicates factory default)
Pixel Value Check When "Gamma/EOTF" is set to "SMPTE ST 2084 (PQ)" or "Hybrid Log-Gamma", the luminance and
RGB value of the specified pixel (cursor) position are measured and displayed. The pixel value check
can be used when the resolution is "4096x2160", "3840x2160", "2048x1080" or "1920x1080".
Note
• Settings of the video display that cannot be displayed, or input signal status ( 93 )
• The update time for "Pixel Value Check" may take a long duration when displaying the "Pixel
Value Check" and operating the OSD menu.
Enable Switches the "Pixel Value Check" On, Off.
On, Off
H Position Sets the pixel position (horizontal).
1 to 4096 (960)
V Position Sets the pixel position (vertical).
1 to 2160 (540)
Reset Position Sets operation when the RESET button is pressed.
Normal : Resets the value to the default value.
Around Peak Luminance : Moves closer to the area of peak luminance inside the display image.
Test Pattern Sets the test pattern built into the main unit.
White (1023), White (940), Gray, Black (64), Black (0), Ramp, Color Bars, Color Bars (PQ
Full), Color Bars (PQ Limited), Color Bars (HLG), PLUGE, PLUGE (PQ/HLG), Off
Note
• If the power is turned off once and then back on, the test pattern will not be displayed.
• The test pattern will be erased in the following cases:
- When calibration has been started
- When a channel is changed using the CH button, F button assigned for Channel UP/
Channel DOWN, or "Select Channel" under "Channel Settings"
- When changing "Input Configuration" or "Select Input Signal" under "Channel Settings"
- When "Reset All Settings" is executed
Signal Monitoring Monitors the input signal status.
Note
• "Signal Monitoring" cannot be used in the following cases:
- When "Single Input Dual View" is displayed
- When an enlarged image is displayed
- During display of the test pattern
- During execution of "Playback File" under "Screen Capture"
• When an error is displayed, "In Monitor Display" will not be shown.
• The position the error is displayed can be adjusted with "In Monitor Display"
→ "Position".
Control Sets whether "Signal Monitoring" is used or not.
On, Off
Error Hold Sets the length of time for displaying errors, when they are detected.
On (No time out) : Errors continue to be displayed. To hide the displayed error, press the RESET
button when closing the OSD menu.
On (5 sec.) : The displayed error will disappear 5 seconds after the initial detection.
Off : Only displays errors during the period when they are detected. The displayed error message will
disappear once the error ends.