Canon DP-V2421 4K Reference Display - Manual (Page 92)

92 OSD Menu
Item Setting Options (underline indicates factory default)
Anamorphic When a Canon camera is connected, displays in accordance with the settings when anamorphic
lens display settings are included in the camera metadata.
On, Off
Area Marker When an ARRI cinema camera is connected to this device, the "H Position", "V Position", "Width",
and "Height" for the "Area Marker" change depending on the metadata.
ARRI Frame line 1A, ARRI Frame line 1B, Off
Note
• This cannot be displayed when "Marker Preset" is "Off".
Fan Allows you to link stopping the fan to the camera's recording operation (For Cinema EOS cameras,
Canon professional-use video cameras, or ARRI cinema cameras that are compatible with this video
display). When "Fan Control" under "System Settings" is set to "On", the mode changes so that
the fan can be stopped, and when "Fan" is set to "On", the fan can be stopped by linking with the
camera's REC signal. At room temperature (25 °C), the fan remains off for approximately one minute.
The fan operates at a faster speed than usual before and after the fan is stopped to lower the internal
temperature.
On, Off
Note
• If the temperature inside the main unit increases while the fan is off, the message "Fan will be
rotated as the temperature is high." is displayed and the fan starts rotating approximately ten
seconds later. Since the temperature of the main unit has increased, the fan rotates faster than
usual.
• The video display's fan may start rotating earlier than the camera because the temperature
inside the main unit has increased.
• The fan may not stop in some conditions, for example when used at a high temperature.
Camera Information Sets conditions to display camera information.
Automatic : Camera information is displayed for 4 seconds when the information has changed.
On : Camera information is always displayed.
Off : Camera information is not displayed.