Canon CR-X500 Outdoor 4K PTZ Camera with 15x Optical (White) - Manual (Page 11)

Control connectors
11
Control connectors
LED power indicator
This indicator illuminates when the power is on, and goes out when the power is turned off.
Power switch
This is the switch for turning on/off the power.
AUX terminal
This terminal (HR10A-10R-10S (71) / HIROSE connector) is used to control optional functions. This
can be used as a universal contact circuit.
SDI terminal
This is an output terminal (BNC connector) for uncompressed digital video and digital audio signals.
SYNC terminal
This is an input terminal (BNC connector) for external sync signals.
DC-IN terminal
This is an input terminal for DC power supply. Make sure to use a power cable that is suitable for the installation conditions
(authorized products, environmental regulations) and conforms to the product's power specifications. Power of two or three times
the rating 90 W may be consumed during power-on, so select a power supply with specifications that prevent a power failure.
CONT. terminal
This is an input terminal (EPRC05-R12M / TAJIMI connector) for the
pan-tilt head, lens and camera control signals.
WASHER
12V 500mA
MIC
12V 200mA
AUX
CONT.
SDI
SYNC
START
STOP
receptacle unit
1
2
3
4
5
6
7
8
9
FPU
AUX1
AUX2
AUX3
AUX4
COM
10
AUX terminal's pin assignment
RX+
TX+
RX-
TX-
GND
CONT. terminal's pin assignment
Pin No. Input/output Signal name
Input
Output
Input
Output