Epson 5500C - Manual (Page 31)

1 • Installation 22
c. To also view the video on the computer monitor, connect
the monitor cable to the projector’s Computer Out port.
This is useful when you need to view the video output but
the projection screen is behind you.
d. Tighten the screws on all connectors.
2. If you want to use the remote control as a mouse pointer for the
computer, connect the mouse cable.
Note: If you’ll be using the optional ELP Link III software, skip
step 2, as you’ll need to connect the mouse cable included in the
ELP Link III set instead. Follow the instructions on page 78 to
connect the mouse cable.
a. Disconnect the computer’s PS/2 mouse cable from the
mouse port on the back of your computer and replace it with
the small end of the PS/2 mouse cable included with the
projector.
PS/2 mouse cable
Mouse/Com
port
5500.book Page 22 Wednesday, August 4, 1999 4:41 PM