Epson 5500C - Manual (Page 89)

Connecting the ELP Link III Cables 79
3. Connect the 9-pin end of the PS/2 mouse cable included with
the ELP Link III set to the MOUSE terminal on the square end
of the main cable.
4. If your computer’s mouse cable is still connected to your
computer, disconnect it. Then connect the other end of the PS/2
mouse cable included with the ELP Link III set to your
computer’s mouse port.
Note: If your system uses a serial mouse, perform steps 3 and 4
using the serial mouse cable instead of the PS/2 mouse cable
(not shown in the illustration).
5. To configure the projector from your PC using the ELP Link III
software or to use the Effects buttons on the remote control,
connect one end of the 9-pin serial cable to the SERIAL
terminal on the square end of the main cable.
Note: You will not be able to use the ELP Link III software if
your system has only one serial port that is being used to
support a serial mouse.
6. Connect the other end of the 9-pin serial cable to the serial port
on the back of your computer.
7. Tighten the screws on all connectors.
8. Go to page 85 to install the software.
5500.book Page 79 Wednesday, August 4, 1999 4:41 PM