Honeywell EN2Z-0906GE51 R0708 - Manual (Page 21)

USER GUIDE ARENA/ RANGER
21 EN2Z-0906GE51 R0708
List Display Configuration
A list configuration, for example of a datapoints list, always applies to all lists of the
same kind (in this case all datapoints list) on the same level (site, device, plant,
segment). The appearance of a list, for example, a datapoints list, can be defined by
configuring the following:
• Display columns
Defines, which columns are displayed and in which order the columns are
displayed
• Sort order
Defines the default sort sequence (ascending or descending) within a column
• Default filter
Defines which filter is used by default for the list display
NOTE: The filter definitions apply to all local users of the ARENA.
1. At the bottom of the list, click the Configuration button.
The Variable List Configuration dialog box displays.
2. To configure the columns displayed and their sort sequence, click the Display
Columns tab.
Under Available columns, all columns that can be displayed at maximum are
listed. Under Displayed Columns, all currently displayed columns are listed. The
column display will be configured by moving the columns between the Available
Columns
and Displayed Columns tables using the angle brackets under
Available Columns . The sort sequence of the displayed columns will be
configured by using the upward and downward buttons under Displayed
Columns
.
3. To select the columns to be displayed and their sort sequence, move columns
between the tables and determine sort sequence by doing one of the following:
a. To move single column(s),
In the Available Columns list or in the Displayed Columns table, highlight the
columns to be moved. Multiselection by using the CTRL key is possible.
b. Click the single angle bracket button of the desired direction.
Or,
c. To move all column(s) in one step,
Click the double angle bracket button of the desired direction.
d. To set the sort sequence, that is, the position of the columns within the
displayed list, highlight the column in the Displayed Columns table.
Multiselection by using the CTRL key is possible.