Honeywell EN2Z-0906GE51 R0708 - Manual (Page 50)

ARENA / RANGER USER GUIDE
EN2Z-0906GE51 R0708 50
iLON 10 has been reached and configured successfully, ARENA saves the site
configuration.
9. Create Remote Site through iLON 10 via Modem
The following descriptions refer to an Example of a typical scenario of a
Supervisor ARENA – iLON 10 configuration via modem as shown in the graphic
below.
iLON Configuration
Same as outgoing connection: checked if user name and password
of modem and user name and password of iLON 10 are the same
MODEM
Monitoring (Home) Site (A)
LON Bus
Outgoing Connection Incoming Connection
SERVAL SERVAL SERVAL
PANTHER / TIGER
ALARMS MAINTENANCE CALLS
iLON 10
SITE Configuration and Modem Access
Enabled: must be checked
iLON 10 modem settings:
user name, password, phone number, modem
Supervisor ARENA
Site A
SITE Configuration
Enabled: checked for receiving alarms and iLON
configuration changes
unchecked: for maintenance by ARENA only
iLON Settings
Remote Site (B)
Fig. 14. System Diagram: Remote Through iLON 10 via Modem
CAUTION
Do not switch off or disconnect a modem when operating a modem-connected site.
This causes a malfunction and as a result the need to reboot the PC.
TIP:
Connect PC and modem to the same power supply. In case of a general power
failure, PC and modem will be restarted simultaneously.
10. If not already done, select ´ Modem` in Connect Through under General.
Fig. 15. Site Example: Connect through iLON 10 via Modem (General Settings)