HP 3000CP - Manual (Page 297)

Front-Panel Messages
Message Explanations and Actions
12-15
Set transport
→ Yes
Mode
→ No
You have selected transport mode in the front-panel menu. The printer is waiting for
you to accept or reject the transport mode. Accepting transport mode starts the
process of removing all ink systems.
Press
↑ to accept or press ↓ to reject.
Sheet load
→
Roll load
→
Press
↑ to load sheet media.
Press
↓ to load roll media.
Sheet misaligned
Reload sheet Sheet media is skewed.
Remove it and reload it so that the left and right edges being loaded into the printer
are square. The leading edge must also be straight.
Sheet required
for calibration You have started an accuracy calibration check but media is not present.
Load media.
Sheet / Roll?
Reload media Either: Sheet mode was chosen while loading roll media.
Reload media.
Or: a sheet more than 51 inches (130 cm) long was loaded.
Trim the sheet and reload.
STATUS messages See pages 12-17 through 12-20.
Switch power off You have selected the transport mode shut-down sequence. The printer is waiting for
you to turn the power switch, on the rear of the printer, to off.
Switch off the printer.
Switch power off
Check paper path The printer may be jammed with media.
Turn off the printer. Check the media path and clear it if necessary. Then turn on the
printer.
Switch power off
Check printhead path The printhead carriage cannot move. The printer may be jammed with media.
Turn off the printer. Check the media path and clear it if necessary. Then turn on the
printer.
System Error
060000 The ambient light level in the area of your printer is too bright and is causing the
optical sensor in your printer to malfunction.
Reduce the ambient light level or move the printer to a location where the light level
is lower.
Message Explanation and Action