HP 3000CP User Manual
Page 301
Front-Panel Messages
Message Explanations and Actions
12-19
STATUS
Measuring pattern
The printer is measuring the accuracy calibration print that you just loaded.
Wait for the calibration to complete.
STATUS
Out of media
The printer has received a file, is ready to print, but has no media loaded.
Load appropriate media.
STATUS
Pause pending
You have pressed the
Pause
key but the printer was busy performing a previous
action. The printer will pause when it has completed its current action.
Wait for the current action to complete.
STATUS
Paused
You have pressed the
Pause
key. The printer will remain paused until you press the
Pause
key again.
Press the Pause key again when you are ready.
STATUS
Printing
The printer is printing.
Wait for the printing to complete.
STATUS
Printing (Special)
The printer is printing with a special print mode controlled by your software rather
than by the printer.
Wait for the printing to complete.
STATUS
Processing
The printer has received a file from your software and is processing it ready to print.
Wait for the printing to complete.
STATUS
Ready
The printer is ready to print.
Send a file to the printer.
STATUS
Ready for media
The printer is ready for you to load media.
Load appropriate media.
STATUS
Receiving
The printer has received data.
Wait for further messages.
STATUS
Recovering printhds.
The printer is recovering the printheads after an ink system replacement process
(only for UV Pigmented inks), or you have initiated the printhead recovery
procedure under Utilities / Service Tests/ Recover Printheads.
Wait for the printhead recovery procedure to complete.
Message
Explanation and Action