Hitachi ULTRAVISION UT32S402 - Manual (Page 12)

11
CAUTION
Although this LCD Monitor can be installed using a variety of third party wall mounting brackets/devices, such
third party brackets/devices have not been tested or approved by Hitachi for use or compatibility with this
LCD Monitor. Accordingly, Hitachi accepts no responsability or liability for any injuries or property damage
resulting from the use of such third party brackets/devices. Hitachi strongly advises that any installation of this LCD Monitor
using wall mounting brackets/devices be performed only by a qualified and experienced television installation technician who
has completed a thorough evaluation of:
a) the weight-bearing strength and stability of the intended wall mount surface; and
b) the weight-bearing strength and compatibility of the intended wall mount brackets/device.
D o n o t b l o c k t h e
ventilation holes. In
addition please keep a
cetain distance around
and make sure not to
obstruct ventilation.
Blocking the ventilation
holes might cause fire or
defect.
More than
30 cm (1').
More than
10 cm (4").
Keep
more than
2 cm (0.8")
away from
the wall.
Remove the Stand Base from the Monitor
Install the Wall Mount Brackets on the Monitor using 4 screws (Screws
Specification is shown below ).
Tips to consider for the location of the Monitor.
1
SAFETY PRECAUTIONS (continued)
Wall Mount Setup
2
3
About the Installation
This product is heavy and should be
carried by at least 2 people.
Keep the screws. They may
be used for the Wall Mount
installation.
CAUTION
Please make sure screws are
tightened properly.
The torque should be 1.8~3.0
N.m (18~30 kgf.cm).
WARNING
Remove the 4 screws and raise straight up from tabletop stand.
Screw Mounting Holes (4 places).Don't
use the original flat head screws (A) that
comes in the monitor, for the Wall Mount
Braket. The length is not long enough.
Wall Mount Brackets
Screw Length (A)
Insertion length (B)
Spring Washer (C)
Plane Washer (D)
Wall Mount Bracket (E)
Example :
A = B+C+D+E
A: 11~13 mm.
B: 7~9 mm.
C: 1 mm.
D: 1 mm.
E: 2 mm.
The screw type :Theread ISO M5 (Metric
type, do not use Standard type).
CAUTION
For Wall Mount assembly; please refer to the Installation Manual of the
Wall Mount Unit.
If the Wall Mount Bracket thickness is 1~3 mm. the original screws
removed from the stand base can be used for the Wall Mount installation.
Insertion length ( B) of the screws must be within 7~9 mm. If the length is less than 7 mm, the weight can
not be maintained. If the length is more than 9 mm, a space is created between the Wall Mount Bracket
and the Monitor. This length is very important.
CAUTION
If you purchased
the Wall Mount unit,
please ask for a professional
installer. Do not install by yourself.
This ultrathin unit features
an advanced ventilation
system configured for
vertical installation. A
k n o w l e d g e a b l e a n d
experienced professional
technician can perform
o t h e r m o u n t i n g o r
installation orientations
(e.g., horizontal, tilted)
p r o v i d e d t h a t y o u
specifically inform the
technician of the unit's
specialized ventilation
needs. Call 800-HITACHI
for additional info and
guidance.