Hitachi ULTRAVISION UT32S402 - Manual (Page 43)

42
ENGLISH
Aspect button
FUNCTIONS
Aspect Switching
Each time the ASPECT button of the remote control is pressed, the screen display aspect
is switched in sequence, and the status will be displayed at the bottom of the screen.
A/V Center/Monitor Composite Signal Input
Display Aspect
Watching Standard Definition Pictures 4:3(Analog/Digital TV, Composite, Component, HDMI*)
4:3 16:9
Expanded
Zoom 1
Zoom 2
Watching Standard Definition Pictures 16:9(Digital TV, Component, HDMI*)
16:9
Expanded
Zoom 1
Watching High Definition Pictures (720p, 1080i, 1080p)(Digital TV, Component, HDMI*)
16:9
Expanded
Zoom 1
Real
You can display the image at its optimum condition by selecting display aspect depending on the current output
image as shown below.
Input Signal
Display
Screen
Display
Aspect
To display suitable screen as follows.
When Watching Standard Definition Pictures 4:3:
(4:3 Signal)
4:3
Plays a 4:3 image on screen faithfully. Blanking occurs on
both sides.
16:9
Plays a 4:3 image which enlarges horizontal and vertical size of
the middle in equal scales, and displays both sides appearing
much wider.
Zoom 1
Use these aspect modes to zoom in on conventional (4:3)
sources.
Zoom 2
Use these aspect modes to zoom in on conventional (4:3)
sources further more than Zoom 1.
Expanded
Use this aspect mode to display conventional (4:3) sources
by linearly increasing image expansion from the center
towards the edges of the display area in order to fill it.
*HDMI doesn't support Expanded
When Watching Standard Definition Pictures 16:9:
(16:9 Signal)
16:9 Plays a 16:9 image faithfully showing 95% of the size.
Zoom 1 Use this aspect to Zoom-in once while in 16:9 aspect.
Expanded
Use this aspect mode to display (16:9) sources by linearly
increasing image expansion from the center towards the
edges of the display area.
*HDMI doesn't support Expanded