Furuno GP-1600F - Manual (Page 41)

2 – 17
ROUTE LIST LEG: - - -.- - - nm
- - - - - - - - - - - - - - -
- - - - - - - - - - - - - - -
- - - - - - - - - - - - - - -
- - - - - - - - - - - - - - -
- - - - - - - - - - - - - - -
- - - - - - - - - - - - - - -
WAYPOINT LIST
No LAT/LONG COMMENT
001 BUOY
* 002 ANK
005 PORT
:Cursor ENT:Sel
:Skip CLR:Delete ESC:Esc
34° 45.567' N
135° 23.321' E
34° 45.567' N
135° 23.321' E
34° 42.316' N
135° 21.678' E
Figure 2-21 Route entry screen
5) Press the [NU/CU ENT] key to enable entry of waypoints.
6) Press the [▼] or [▲] key to select waypoint number.
7) Press the [NU/CU ENT] key. The waypoint number selected
appears and the cursor shifts to next column.
8) Repeat steps 6 and 7 to complete the route.
9) When the route is completed, press the [MENU ESC] key three
times to escape.
2.12 Setting Trial Speed
The TTG between legs on the route is calculated based on the trial
speed, which is entered in the route/route list. The default speed is
10 knots. To enter a different speed, do the following:
1) Press the [MENU ESC] key.
2) Press the [4] key to select ROUTE/ROUTE LIST. The route/
route list appears.
3) Place the cursor on waypoint 01 and press the [▲] key, or place
the cursor on waypoint 20 and press the [▼] key.
4) Press ten keys to set the trial speed.
5) Press the [▼] or [▲] key to escape.
6) Press the [NU/CU ENT] key.
7) Press the [MENU ESC] key twice to escape.