Furuno GP-1600F - Manual (Page 87)

6 – 9
6.8 Demonstration Display
The demonstration display provides simulated operation of this
unit. Own ship tracks, at the speed selected, a figure eight course,
starting from position entered. All controls are operative; you may
set destination, enter marks, etc.
1) While pressing and holding down the [NU/CU ENT] key, turn
on the power. The display shown below appears.
DEMO SETTING
BASE POSITION
_
°
_ _ . _ _ _'N _ _ _
°
_ _ . _ _ _'W
SPEED:
00.0kt
ts:Cursor t:Column
ENT:Enter :N/S, E/W
Figure 6-8 DEMO SETTING screen
2) Key in latitude and longitude for base position. If necessary,
press [ ] to switch from North latitude to South latitude or
vice versa, or from West longitude to East latitude or vice versa.
3) Press the [▼] key.
4) Enter ship's speed.
5) Press the [NU/CU ENT] key to start the demonstration dis-
play.
6) To quit the display, turn off the power.
Note: To return to the normal mode, turn off the power and then
turn on the power while pressing and holding down [NU/CU ENT]
key.
Note: When the memory is cleared while in the demonstration
mode, the unit start up in the normal mode.