Furuno GP-1600F - Manual (Page 86)

6 – 8
6.7 Memory Card Operations (for technicians)
Before changing the internal battery, save the contents of the
memory (waypoint, event, mark, track, route data and menu set-
ting data) to a memory card (256 K bytes).
Saving data
1) Press the [MENU ESC] key.
2) Press the [7] key to select MEMORY SAVE/LOAD.
3) Press the [▲] key to select SAVE MEMORY.
MEMORY SAVE/LOAD
SAVE MEMORY NO YES
LOAD MEMORY NO YES
▼▲ : Cursor : Go ESC: Esc
Figure 6-7 MEMORY SAVE/LOAD menu
4) Press the [s] key. The message window appears.
5) Press the [NU/CU ENT] key. The card is formatted and data
are saved. When saving is completed, the cursor moves to NO
at the SAVE MEMORY line.
6) Press the [MENU ESC] to escape.
Note: "Memory card err" appears in the folllowing cases:
• No card is set
• Card is write-protected
• Card error
Loading data
Data stored on a memory card can be loaded as follows:
1) Press the [MENU ESC] key.
2) Press the [7] key to select MEMORY SAVE/LOAD.
3) Press the [▼] key to select LOAD MEMORY.
4) Press the [s] key to select YES. The message window ap-
pears.
5) Press the [NU/CU ENT] key. After the plotter data is loaded,
the system is reset and the initial display appears.