Meridian Audio M3900 - Manual (Page 95)

Installation Page 95 of 174
M3900 Series Meridian Digital Telephones Description, Installation and Administration
3 Click on Start.
4 Select Run.
5 Enter a:\setup (assuming that drive “a” is your floppy disk drive).
6 Click on OK.The Nortel Networks logo screen appears while the
installation utility loads.
7 The Welcome screen appears.Click on Next to continue installation.
8 If you agree to the terms of the Software License Agreement, click on
Yes.
9 Continue to Click on Next until the installation is complete.
10 When asked to, remove the disk from your floppy disk drive.
11 Click on Finish.
Note: You must restart your PC to access the Personal Directory PC
Utility.
12 To select a port for the Personal Directory PC Utility; click on Phone.
Click on Set port.The pull-down menu shows available PC ports:
• Com1
• Com2
Note: The program selects the same port each time until you change
it.
To install the Key-based Expansion Module Accessory
The Key-based Expansion Module Accessory (KBA) provides 22 additional
line/feature keys for the M3904 and M3905 Meridian Digital Telephones.
You can add up to two Key-based Expansion Modules providinga total of 75
line/feature keys.
To install the Key-based Expansion Module:
1 While depressing the telephone tilt handle, pull the telephone away
from the footstand until it clears the final stop.Gently pull the footstand
off the clips.
Note: If an ACM is installed, unplug the ACM and remove it from the
the footstand.Install the ACM in the Single KBA Footstand Assembly.