Meridian Audio M3900 - Manual (Page 98)

Page 98 of 174 Installation
553-3001-216 Standard 5.00 January 2002
To install the Expansion KBAFootstand
1 Place the Single KBA Footstand and the Expansion KBA Footstand
face down on a flat surface.
2 Align the Expansion KBA Footstand with the Single KBA Footstand
and slide them together.
3 Insert two screws through the Expansion KBA Plate into the Single
KBA Footstand.
4 Tighten all four screws, ensuring that the two footstand assemblies are
properly aligned.
5 Insert the clips on the telephone and the Key-based Expansion
Modules into the hinges on the combined Single Expansion KBA
Footstand Assembly, and while squeezing the Module Tilt Handles,
swing the footstand into the desired position.
6 Turn the completed assembly upright.
To install the Display-based Expansion Module
The Display-based Expansion Module gives you three layers of eight
Programmable Line/Feature (Self-labeled) Keys. The Display-based
Expansion Module gives you a total of 24 Programmable Line/Feature Keys
(Key 32 through 55).
The Page button allows you to scroll to each key layer. The Self-labeled field
is 10 characters in length. You can customize the Display-based Expansion
labels usingthe program mode and the dial pad keys.
To install the Display-based Expansion Module:
1 While depressing the telephone tilt handle, pull the telephone away
from the footstand until it clears the final stop.Gently pull the footstand
off the clips.
2 Place the telephone and the Display-based Expansion Module face
down on a padded level surface, and align them.
3 Lower the Module into place, and insert the 10-pin plug on the Module
into the 10-pin slot on the telephone.Push in gently until the retaining
tabs snap into place.
4 Insert the clips on the telephone into the hinges on the footstand, then
press on the front of the footstand until it snaps into place.