Furuno GP-3500 - Manual (Page 106)

8. ALARMS
8-2
8.1 Audio Alarm On/Off
The audio alarm sounds whenever an alarm setting is violated. You can enable
or disable the audio alarm as follows:
1. Press the [MENU] key to show the main menu.
2. Press the [6] key to show the ALARMS SETUP menu.
AUDIO ALARM 1. SHORT 2. LONG 3. CONT 4. OFF
ARRIVAL/ANCHOR WATCH 1. ARRIVAL 2. ANCHOR 3. OFF
RANGE TO MONITOR 0.001 nm
XTE/BORDER ALARM 1. XTE
2. BORD 3.OFF
RANGE TO MONITOR 0.050nm
PROXIMITY ALARM
1. ON 2. OFF
SPEED ALARM 1. INSIDE 2. OUT 3. OFF
MINIMUM SPEED 000.0kt
MAXIMUM SPEED 030.0kt
TRIP LOG ALARM 1. ON 2. OFF
DIST TO MONITOR 0000.1nm
TEMPERATURE ALARM 1. INSIDE 2. OUT 3. OFF
MINIMUM TEMPERATURE +00.0
°
C
MAXIMUM TEMPERATURE +30.0
°
C
SHEAR ALARM 1. ON 2. OFF
GRADIENT OF TEMP 00.1
°
C 0.1
∼
10.0
INTERVAL 010 s 10
∼
120 s
BOTTOM ALARM 1. ON 2. OFF
DEPTH 0000.0ft
RANGE 00.0ft
6. ALARMS SETUP
TURN KNOB TO SELECT MENU.
SELECT THE ITEM OF EACH MENU BY TRACKBALL.
Alarm setup menu
3. Rotate the [ENTER] knob to select AUDIO ALARM.
4. Roll the trackball in left-right direction to select an beep type
SHORT: Short beeps sound.
LONG: Long beeps sound.
CONT: Continuous beep sounds.
OFF: Audio alarm off.
5. Press the [MENU] key several times to close the menu.