Furuno GP-3500 - Manual (Page 167)

10. RECORDING & PLAYING BACK DATA
10-17
10.5.2 Uploading data
Data in the PC can be uploaded to the working memory.
Note: When waypoint or route data are uploaded, all data in the internal memory
will be replaced with the uploaded data.
1. Connect the PC to the equipment.
2. Press the [MENU] key to show the main menu.
3. Press the [3] key to show the MEMORY CARD OPERATIONS & DATA
TRANSFER menu.
4. Press the [9] key to show the DATA TRANSFER menu.
5. To upload mark/line, rotate the [ENTER] knob to select MARKS & LINES of
TRANSFER FROM PC.
6. Press the [1] key to select “1.YES.”
7. To upload waypoint/route, rotate the [ENTER] knob to select WAYPOINT &
ROUTE of TRANSFER FROM PC.
8. Press the [1] key to select “1. YES.”
9. Set RS-232C referring to paragraph 10.5.1.
10. Rotate the [ENTER] knob to select TRANSFER FROM PC.
11. Press the [1] key to select “1. YES.”
One of the following message appears.
UPDATE DATA
FROM PC?
YES ... PRESS KNOB
NO ... PRESS CLEAR KEY
Mark/line Waypoint/Route
ALL WAYRINTS &
ROUTE WILL BE DELETED.
ARE YOU SURE?
YES ... PRESS KNOB
NO ... PRESS CLEAR KEY
12. Press the [ENTER] knob to upload data.
You are asked if you are sure to upload data.
The message “UPDATING FROM PC NOW” appears. When the updating is
finished, the message “UPDATE IS COMPLETED. PRESS ENTER KNOB.”
appears.
13. When the uploading is completed, press the [ENTER] knob.
14. Press the [MENU] key several times to close the menu.