Furuno GP-3500 - Manual (Page 14)

1. BASIC OPERATION
1-4
1.3 Turning the Power On/Off
Turning the power on
Press the [POWER] key until you hear a click and two beeps sound.
When the unit is turned on, it proceeds in the sequence shown in the figure in
below.
START UP TEST
PLOTTER
ROM : OK
RAM : OK
BACKUP DATA : OK
INTERNAL BATTERY : OK
INTERNAL GPS : OK
ECHO SOUNDER
ROM : OK
RAM : OK
--- CAUTION ---
NO NATIONAL HYDROGRAPHIC
OFFICE HAS VERIFIED THE
INFORMATION IN THIS
COASTLINE DATA CARD AND NONE
ACCEPT LIABILITY FOR THE
ACCURACY OF REPRODUCTION OR
ANY MODIFICATIONS MADE
THEREAFTER. THIS PRODUCT WITH
THIS COASTLINE DATA CARD
DOES NOT REPLACE THE
REQUIREMENT TO USE THE
APPROPRIATE PRODUCTS FOR
NAVIGATION ACCORDING TO
NATIONAL AND INTERNATIONAL
REGULATIONS.
CHART CARD. US603S32, US223S32
PROGRAM NO.
PLOTTER : 1451712-XX.XX
GPS : 48502640XX
GP-3500
GPS PLOTTER
FURUNO ELECTRIC CO. LTD.,
XX: Program Version No.
In about 30 seconds the last-
used display appears. You
can go the last-used display
faster by pressing any key.
C-MAP NT: 1451714-XX.XX
Start-up sequence
Note 1: The example screens shown in this manual may not match the screens
you see on your display. The screen you see depends on your system
configuration and equipment settings.
Note 2: If the message "SYSTEM HAS FAILED START UP TEST. PLEASE
CONTACT A LOCAL FURUNO REPRESENTATIVE FOR REPAIR.
PRESS ANY KEY TO CONTINUE." appears, contact your dealer for
advice.
This equipment takes about 90 seconds to find its position when turned on for
the very first time. Thereafter it takes about 12 seconds to find position each time
the power is turned on. The message "NO FIX", which means the equipment is
mow findings its position, appears at the bottom of the Plotter (or Pilot) display
immediately after turning the power on. When the GPS receiver finds its position,
"NO FIX" changes to "2D" or "3D" to show that position data is now accurate.