Fluke Ti50 - Manual (Page 39)

3-1
Chapter 3
Basic Operation
Acquiring and Reviewing Images
Your Camera has three operating modes: scan target, pause/save, and
view/delete images.
Scan Target
To scan target area of interest:
1. Press D to power on the camera.
2. Remove lens cap and point the lens at the target area.
3. Focus and view the target area on the display screen.
4. Tap G to set the camera’s temperature level and span; tap G again as
needed to quickly bring the target area into view.
5. Move the camera or lens module as necessary to view various scenes.
Pause/Save Image
To pause and then save a target area image, follow the Scan Targe procedure,
then quickly tap the TRIGGER button. The word “Paused” appears in the
upper left corner of the display, and the live target area image is paused
enabling you to analyze the image and determine if it is acceptable enough to
save. If not, quickly tap the TRIGGER button again to return to scan target
mode. If image is acceptable, you can save it for future reference.
To save an image for future reference, make sure CompactFlash memory card
is inserted (see Chapter 2) and follow the procedures under Scan Target. When
an area of interest is visible on the display screen, press and hold the
TRIGGER button until the hour glass is displayed (approximately 2-3
seconds). The image is now saved and stored on the CompactFlash memory
card. See Naming Image Files in Chapter 6.
The image name is displayed in the upper left corner of the display screen.