Fluke Ti50 - Manual (Page 89)

Camera Care
Conserving Battery Power
8
8-5
Note
Recalibration may take up to 16 hours. You can charge a battery in
the right charging bay while recalibrating a battery in the left bay.
To recalibrate a battery:
1. Insert the battery into the left bay of the battery charger.
2. Press the recalibrate button on the front of the charger.
Conserving Battery Power
To conserve battery power (when the camera is running on battery power, not
AC power), the display screen automatically powers off and the system goes
into standby mode when the system has been idle for 5 minutes (you can
change this time). The camera automatically powers off when the system has
been in standby for 10 minutes (you can change this time). You can manually
switch to standby mode as well.
To manually switch from full power to standby mode, tap D once. D
flashes green.
To switch from standby mode to full power, tap D once again. D
remains solid green.
To power on or off, press and hold D for 4 seconds. D remains solid
green when power on; no light when power off.
To change the standby timeout time:
1. Tap F.
2. Use the MOUSE controller to position the pointer over Camera Settings
on the popup menu.
3. Tap E.
4. Position the pointer over the Power tab and tap E.
5. Position the pointer over the Standby Timeout down arrow and press E.
6. Position the pointer over the time you want and press E
7. Tap the TRIGGER button to accept setting change and return to scan
target mode.