Fluke Ti50 - Manual (Page 57)

5-1
Chapter 5
Visible Light Camera Module (VLCM)
Note
This Chapter applies only to cameras with IR Fusion.
Enabling/Disabling Visible Light Camera
Module
To enable/disable the visible light camera module:
1. Tap F.
2. Use the MOUSE controller to position the pointer over Camera Settings
on the popup menu and tap E.
3. Position the pointer over the VLCM tab and tap E.
You may need to position the pointer over the right or left arrow and tap
E
to scroll to the VLCM tab.
4. Position the pointer over the Enable Visible Light Camera box; tap E to
add or remove a check mark. A check mark indicates the function is
enabled.
5. Tap the TRIGGER button to accept setting change and return to scan
target mode.