METRObility Optical Systems 8124-01-M - Manual (Page 52)

52 CenturyStack 8100 Managed Hub
4. Press <Next> to scroll through each configuration item.
5. Press <Enter> to apply the currently displayed configuration
to the port.
The applied configuration is indicated by an asterisk sign displayed before
the name of the configuration in the Message Zone as shown below,
otherwise, the asterisk sign does not appear.
Current Port Configuration (single port)
The table lists typical default settings and the possible optional settings
for a port. An “*” appears before each current setting. To change a setting,
press and hold down Enter until an “*” appears before the desired setting,
the “*” is removed from the previous setting.
Port Setting
Default Optional Settings
*AUTO-NEGO 10BASE-T/100BASE-X
*ENABLE Disable
Unit Configuration
You can configure the hub using the Unit Configuration Menu. For
security reasons you are prompted for the password when the device is
locked. Without the password users cannot enter the Unit Configuration
menu in order to change any unit configurations. When the device is
unlocked, no password verification is required to change the unit configu-
rations. The password entry is described in “Set Password.”
ID
Master
WWW
SNMP
O-O-B
10
20
40
1
3
5
80
K % 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 G-A
G-B
G-C
G-D