METRObility Optical Systems 8124-01-M - Manual (Page 89)

Master Hub Configuration & Console Management 89
Bridge Module Control
This control lists the configurable functions and provides option fields;
use Ctrl + S to toggle between options.
External Function Admin State: The default value is Disable.
•
Enable: Enables the external bridge function.
• Disable: Disables external distance extender function of a
given module. Once the distance extender function is
disabled, you must enabled it to restore external distance
extender operation.
Internal Function Admin State: The default value is Disable.
•
Enable: Enables the internal bridge function. The internal
hardware Jumper switch must also be enabled for the
internal bridge to function.
NOTE: The internal bridge must be enabled in hardware
with the Jumper switch settings before the Admin state
can be enabled. Refer to Chatper 2: Using Expansion
Modules.
• Disable: Disables the internal bridge function. Once the
internal bridge function is disabled, then you must enable
it to restore internal bridge operation.
NOTES:1. These modules are not “hot-swappable”.
You must remove power from the hub before installing
or removing the modules. 2. You should enable the internal
bridge on only one switch module if you have multiple
bridge modules installed in the stack. This prevents a
network loop condition.
External Port Link Status Change Notify: When enabled, a
trap is sent to the receiver when link status of the port changes.
•
Enable: The trap is sent to the trap receivers.
• Disable: No trap is sent.