METRObility Optical Systems 8124-01-M - Manual (Page 70)

70 CenturyStack 8100 Managed Hub
Interface: The current interface number; 1=Ethernet, 2=SLIP
Interface T ype: The interface type — Ethernet or SLIP
MAC Address: Displays the hub’s MAC Address, for example:
00-E0-95-00-00-05.
IP Address: The dotted decimal address assigned to the
CenturyStack.
Subnet Mask: The dotted decimal subnet mask assigned to the
CenturyStack.
Default Gateway: The dotted decimal IP address of the default
gateway assigned to CenturyStack. CenturyStack must be
restarted before the IP address, subnet mask, and default
gateway can take effect. To ensure that the new information is
correct, a “ping” should be done from another device connected
to the CenturyStack.
NOTE: The hub does not respond to ping packages that are
greater than 1484 bytes.
Local Console/Remote Telnet-SLIP
SLIP connections enable monitoring and configuring the CenturyStack
remotely with a modem. To make SLIP connections use Network
Interface <2> and set the configurations shown below.
NOTE: The SNMP agent, TCP/IP stack and the Web engine are
implemented on the 10Mbps bus of the master hub. Therefore the 10Mbps
segment must be used for Web-Based Management in the absence of a
switch module.