METRObility Optical Systems 8124-01-M User Manual
Page 59
Managing Through the Mini Console 59
Restarting the Hub
The hub will use your configurations to set up the system when it restarts.
Restart the system with the Restart Menu using the following steps:
1. Scroll to UNIT CONFIG and press <Enter>.
2. Scroll to SYS RESTART and press <Enter>.
3. Press <Enter> at “CONTINUE” or press <Next> to abort
the action at the menu option “CANCEL”.
4. Press <Enter> to confirm.
System Restart-Continue
Restoring System Default Setup
The factory default configurations are selected from the SYS DEFAULT
menu, a sub menu of the Main Menu item “UNIT CONFIG”. The factory
defaults are the settings that were set at the factory before shipping the
hub. Restore the default settings with the following steps:
1. Press Enter at the “SYS DEFAULT” menu option.
“CONTINUE” displays in the Message Zone.
2. Press <Enter> to restore factory defaults or press <Next> to
scroll to CANCEL and press Enter to cancel the operation.
CAUTION: Restoring the system default settings overwrites
all custom settings, including password, port configurations,
and unit configurations.
ID
Master
WWW
SNMP
O-O-B
10
20
40
1
3
5
80
K % 1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
G-A
G-B
G-C
G-D