MicroNet Technology SP5001/S - Manual (Page 52)

51
19.2 Power Up Your SP5001/S
At this point, you should have connected the console port, the LAN Port, the WAN port
and the power port to the appropriate devices or lines. Plug the power adapter into a
wall outlet. The Power LED should be on. The Status LED will come on after the
system tests are complete. The WAN LED and one of the LAN LEDs come on
immediately after the Status LED come on, if connections have been made to the LAN
and WAN ports.
Initial Screen
When you power on, your SP5001/S will perform server internal tests as well as line
initialization.
After the tests, SP5001/S asks you to enter the Login, as shown.
Attached TCP/IP interface to cpm unit 0
Attaching interface lo0...done
Please wait while system is initializing .......... SAttached TCP/IP interface
to cpm unit 0
Attaching interface lo0...done
WorkMode : PEER2PEER_MODE
AC4804[0] is ok
successful 1 2
Initialize OSS libraries...OK!
VP v1.40 stack open successfully.
login:
Figure 34. Initial Screen
Entering Login
For you first login, enter the login root and default password “Null”. As you type the
password, the screen displays and (*) for each character you type.
AC4804[0] is ok
successful
Initialize OSS libraries...OK!
VP v1.40 stack open successfully.
login:root
Welcome to Terminal Configuration Mode
Please enter your configuration item
usr/config$
Figure 35. Login Screen
Note: root or administrator is the default login name and there is no password needed.