MicroNet Technology SP5001/S - Manual (Page 67)

66
19.7.4 [flash]
Save changes after configuring SP5001/S.
usr/config$ flash
Flash memory information and configuration
Usage:
flash -clean
Note:
This command will clean the configuration stored in
the flash and reboot it.
usr/config$
Figure 41. flash command list
Parameter Usages:
-clean clean all the user defined value, and reboot SP5001/S in factory
default mode.
Note: It is recommended that use “flash –clean” after application firmware id
upgraded.
Warning: It is only executed by user whose login name is root. All
configurations in command [ifaddr], [pppoe] will be kept
usr/config$ flash -clean
Flash clean start
Flash clean success!!
!! rebooting ...
Attached TCP/IP interface to cpm unit 0
Attaching interface lo0...done
HTTPD initialized...
Flash Check
WorkMode : PROXY_MODE
Start registering to Proxy server
AC4804[0] is ok
successful 1 2
Initialize OSS libraries...OK!
VP v1.42 stack open successfully.
login:
Figure 42. flash –clean command list