MicroNet Technology SP5001/S - Manual (Page 74)

73
19.7.11 [sysconf]
This command displays system information and configurations.
usr/config$ sysconf
System information and configuration
Usage:
sysconf [-idtime digit] [-bf digit] [-keypad dtmf]
[-faxtype type][-2833type type][-lcdrop ON/OFF]
[-droptime digit][-eod digit]
sysconf -print
-print Display system overall information and configuration.
-idtime Inter-Digits time.(1~10 sec)
-bf BusyForward.(ON:1 / OFF:0)
-keypad Select DTMF type: 0=In-band,
1=RFC2833.
-faxtype FAX Payload Type (range:96~128
inter-used:100,102~105)
-2833type RFC2833 Payload Type (range:96~128
inter-used:100,102~105)
-lcdrop Disconnect Supervision (Loop Current Drop) (ON:1 / OFF:0)
-droptime Period of Loop Current Drop (ms)
-eod End of Dial Digit setting(0: none, 1: *, 2: #)
Example:
sysconf -keypad 0 -eod 2
usr/config$
Figure 52. system information command list
Parameter Usages:
-print print current settings
-idtime set the duration (in second) of two pressed digits in dial mode as
timed out. If after the duration user hasn’t pressed next number,
LAN Phone will dial out all number pressed.
-bf Only working in Proxy mode.
-keypad DTMF relay type. When value is “1”, SP5001/S will transfer
DTMF signal via RTP payload as defined in RFC2833. When
the value is set to “0”, the DTMF type is set as In-band.
-faxtype FAX Payload Type. Range: 96~128 inter-used:100,102~105.
-2833type RFC2833 Payload Type. Range: 96~128
inter-used:100,102~105.
-lcdrop Disconnect Supervision (Loop Current Drop) (ON:1 / OFF:0).
-droptime Period of Loop Current Drop (ms).
-eod to define end of dial digit. (0: none, 1: *, 2: #).