MicroNet Technology SP5001/S - Manual (Page 69)

68
Parameter Usages:
-print print current IP setting and status
-ip assigned IP address for SP5001/S
-mask internet subnet mask
-gate IP default gateway
-dhcp Dynamic Host Configuration (1 = ON; 0 = OFF)
-sntp Simple Network Time Protocol (1 = ON; 0 = OFF) When SNTP
function is activated, users have to specify a SNTP server as
network time source. An example is demonstrated below:
-dns Specify Primary (-dns 1) or Secondary (-dns 2) DNS Server IP
address.
usr/config$ ifaddr -dns 1 168.95.1.1
usr/config$ ifaddr -dns 2 203.23.123.2
-timezone set local time zone according to GMT
usr/config$ ifaddr -sntp 1 10.1.1.1
While 10.1.1.1 stands for SNTP server’s IP address.
-ipsharing To specify a global fixed IP address, user can add this IP address
in the command.
usr/config$ ifaddr -ipsharing 1 210.11.22.33
-upnp Enable/ Disable UPnP function. If IP sharing has this function, use
can enable upnp function that user doesn’t need to configure
gateway or IP sharing for NAT function.
usr/config$ ifaddr -print
Internet address information
IP address : 192.168.4.72
Subnet mask : 255.255.0.0
Default gateway : 192.168.1.254
DHCP startup : OFF
SNTP : mode=1
server 168.95.195.12
time zone : GMT+8
cycle=1024 mins
IPSharing : no IPSharing device.
Primary DNS Server : 168.95.1.1
Secondary DNS Server : 168.95.1.1
usr/config$
Figure 45. ifaddr –print command list