MicroNet Technology SP5001/S - Manual (Page 53)

52
Set Password
To set your own password in root login name, just input command “passwd –set root
****”. For example, if password of root account is prepared as ”voip”, configuration is
usr/config$ passwd -set root voip
Setting
Login: root
Password: voip
OK
usr/config$
Figure 36. Change password Screen
19.3 Command Structure in SP5001/S
You can use text command lines for software configuration. The rules of the
commands are listed next. The command keywords are in courier new font.
1. The command keywords must be entered exactly as shown, that is, no
abbreviations are allowed.
2. “Command” refers to a command used in the command line interface.
19.3.1 Command Structure in SP5001/S
SP5001/S uses a two-level command structure. The commands related to
one subsystem are group under a primary command of that subsystem, for
instance, to configure the parameters, you must fist enter the usr/config$
subsystem by entering the ifaddr command. When you are in a subsystem,
the system reminds you by including the subsystem name in the command
prompt, for example,
usr/config$
19.3.2 Set up IP Address
Use command “ifaddr” to configure Gateway’s IP Address and related
information. For example
usr/config$ ifaddr – ip 10.1.1.1 – mask 255.2555.255.0 – gate 10.1.1.254
Description: This is to configure IP Address as “10.1.1.1”; subnet mask as
“255.255.255.0”; default router gateway as “10.1.1.254”.
Note: After configured the IP Address and did the [commit], then [reboot]
process, user can start to do other configurations via HTTPD.