MITSUBISHI ELECTRIC SDP-Eco 1630 III User Manual
Page 35
4.4 Data input for the set plate (This procedure is necessary when
loading the plate.)
(1) Press the
key to display the
.
(2) Press the
key to display
, which is a lower
level of the
menu.
(3) Use the
key to select the data registration number, plate type, plate
width, or length of plate roll, then press the
key to flash the cursor
(indicating mode change).
(4) Press the
key after changing the data using the
or
key.
• Input the plate data and press the
key. Press the
key once to call
up the
display and press the key once more to call up
the
display and switch to the on-line mode.
(Example)
1) Selection of Data Memory Channel (From M0 to M3)
Press the
key in order to start the
cursor key flashing and select M0 to
M9 using the
key or the
key. Press the
key to register the
data channel.
2) Selection of plate type (From F100 to F175)
Press the
key or the
key to
move the cursor to the F100 display
(plate type). Press the
key to
start the cursor flashing. Select the
plate type (F175, R175) using the
key or the
key and press
the
key to register the plate type.
3) Selection of the plate width (From 404 to 414)
Press the
key or the
key to
move the cursor to the 404 display
(plate width). Press the
key to
start the cursor flashing. Select the
plate width using the
key or the
key and press the
key to
register the plate width.
ENT.
ENT.
ENT.
ENT.
ENT.
ENT.
Start OK
< Plate Data >
MENU
ENT.
Note
ENT.
ENT.
< Plate Data >
M0 R 1 7 5 414 00m
ENT.
< Plate Data >
MENU
Chapter 4 Operation
- 27 -
M 0 F 1 7 5 4 1 4 6 1 m
M 3 F 1 0 0 4 0 4 3 7 m
If setting
M3
Cursor
M3 F100 404 37m
M3 F175 404 61m
M3 F175 404 61m
M3 F175 414 61m