MITSUBISHI ELECTRIC SDP-Eco 1630 III - Manual (Page 79)

Chapter 8 Message
8.6 Jam removal procedure
• Removing Plate jam 1 and 2
- Plate jam1 is displayed when the cutter stops a plate cutting operation
midway.
- Plate jam2 is displayed when the plate can not be cut and is continuously
discharged.
1) Press the key. This stops the
buzzer sound and returns the
cutter to its home position.
2) Open the front door and remove
the cutter cover.
3) Confirm that the cutter blade is not
worn or bent. If it is, replace it
with a new blade.
4) Re-attach the cutter cover and
close the front door.
5) Press the key again and run
the cutter from the maintenance
screen to cut the plate.
6) When the cutting operation is
completed, run the processor to
discharge the plate.
- 71 -
Remove the
cutter unit
cover.