MITSUBISHI ELECTRIC SDP-Eco 1630 III - Manual (Page 53)

Chapter 6 User menu
• Dryer level selection
When setting the dryer temperature, you can select either automatic or manual
(Hi or Low). Select the temperature setting which suits your plate type and
the environmental conditions.
If you select automatic setting, the dryer temperature will be set to "Hi" for
FR100 and FRm175 plates, and "Low" for RR175.
• Stand-by mode ON/OFF
Either activate (ON) or deactivate (OFF) the stand-by mode as follows.
ON: The Stand-by mode is active.
OFF: The Stand-by mode is inactive.
6.6 Maintenance menu
This menu is used when a plate is jammed, the processor is operating, etc.
• Cutter
If a plate is jammed in the machine, the cutter can often be used to help free
and discharge the plate. The cutter returns to its original position after cutting
a plate.
• Processor
The processor can be activated independently of the exposure unit.
• VER
This command displays the version numbers of the software in the machine
(MCON software which controls SDP-Eco 1630 III operations and SRAM
software which controls the SCSI interface).
• SCSI-ID
This command allows you to set/reset SCSI-IDs. Note that after changing a
SCSI-ID setting, you must turn OFF the power and reboot the entire system
including the SDP-Eco 1630 III itself.
6.7 Rinse
The machine is provided with the software counter that functions to warn
operators when the rinse water lowers than the designated level. The warning
is issued in a message and does not prevent output operations.
• When the recorder has received the exposure data from the host computer
(RIP computer) while the "Rinse Tank Check" message is displayed, this
message disappears, and then the exposure is performed. After the exposure
has been finished, the "Rinse Tank Check" message is displayed again.
Note
- 45 -