MITSUBISHI ELECTRIC SDP-Eco 1630 III - Manual (Page 61)

Chapter 7 Maintenance
- 53 -
If the diffusion sheet is
curved or bent, loosen the
sheet retainer on the
processing chemical supply
guide and replace the
sheet with a stand-ard
diffusion sheet.
9) Wash the processing chemical supply guide diffusion sheets (SLM-EAC
x 2, SLM-EST x 1) with water and wipe them dry with a clean cloth.
10) Wash the processor rack and overflow tray with water.
The synthetic rubber used for the processor rack roller is susceptible to high
temperatures, so don't wash it with water that is warmer than 40˚C. Never use
detergent or other cleaning solutions.
11) Re-attach the supply guides to the processor rack.
• Cleaning the processing chemical
tank and filter
Always clean the
processing chemical tank
and filter when you replace
the processing chemical
every three months or after
processing 1000m
2 of
plates.
1) Lift the upper cover for the
processing tank and pull out the
tank.
- The upper cover for SLM-EAC is attached to a panel heater, so it
may be very hot. Be very careful when performing this operation.
- Sensor cords are connected to the upper cover. Do not forcibly pull
at these cords.
Note
Note
Note
Diffusion sheet
Diffusion sheet
SLM-EST
SLM-EAC
Upper cover
Processing tank
Caution
Brush bar