MITSUBISHI ELECTRIC SDP-Eco 1630 III - Manual (Page 74)

SDP-Eco1630 III USERS MANUAL
- 66 -
Procedure
Item
Period
Day
Month
Y
ear
SDP-Eco 1630 III Maintenance and Inspection Chart
Supervisor
Date
Blow the dust and dirt of
f the lens with a
blower
. (Be careful not to scratch the
lens.) Replace the blade following the noted replacement procedure. Remove the filter and clean it.
Every three months.
Discard the punch dust. (An alert message appears after every 1000 punches. Thoroughly read the instruction manual.
Every three months.
Thoroughly read the instruction manual. Thoroughly read the instruction manual. Thoroughly read the instruction manual. Thoroughly read the instruction manual. Thoroughly read the instruction manual.
1 2 3 4 5 6 7 8 9 10 1
1
12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31
NT
cutter blade
Cylindrical lens
As necessary
Filter cleaning Optional punch unit Processor section cleaning
1. Please read the instruction manual carefully
. 2. Mark the date when the inspection is performed. 3. Copy this sheet and use
this same form every month.
As necessary
W
ashing tank
cleaning Processing chemical tank cleaning and chemical replacement Processing chemical supply pipe cleaning Upper and lower exit roller and rinse water nip roller cleaning Rinse water
Every one month
Every three months or after processing 1000m
2
of plates
Every three months
Every month or after processing 1000 plates
Every day