MITSUBISHI ELECTRIC SDP-Eco 1630 III - Manual (Page 73)

7.8 List of expendable parts
- After 25000 prepress processes, a "Pump Check" message appears on the
display panel when the power switch is turned ON.
This indicates that it is time to replace the pump, so please contact the
serviceman and request a pump replacement.
Always replace the pump units for EAC and EST at the same time.
Clear this panel display by pressing the RESET key and continue the initial
inspection.
- Average lifetime varies depending on the usage condition (input voltage,
ambient environment, temperature, humidity, and daily maintenance).
- When expendable parts noted in the list must be replaced, customers will be
charged for labor and parts costs even if the equipment is still within its
warrantee period.
7.9 How to order parts
The SDP-Eco 1630 III has many parts, some of which users can replace on
their own and some which require service personnel to replace. If you wish
to order any parts, please do the following:
(1) Indicate whether you just need the parts, or whether you need to have
them replaced by service personnel.
(2) Information from your warranty or machine name plate
i) Model: SDP-Eco 1630 III
ii) Serial number
(3) Names and numbers of necessary parts, quantities, date required
- Please be aware that new models may be developed and specifications
may change without notice, so parts may differ from those listed in this
operation manual.
- Mitsubishi Paper Mills Ltd. takes no responsibility for improvements
users may undertake on their own or in collaboration with another
company.
Caution
Note
Parts name Parts code Unit When to replace
NT cutter blade 200400107 1 set (contains 10 blades)
After cutting
two plate rolls.
Pump unit (EAC) 1 set
After completing 25000
prepress processes.
Pump unit (EST)
U1105011
U1105012
After completing 25000
prepress processes.
1 set
Chapter 7 Maintenance
- 65 -