MITSUBISHI ELECTRIC SDP-Eco 1630 III - Manual (Page 52)

SDP-Eco1630 III USERS MANUAL
6.3 Pre. Feed menu
Whenever you set a new plate, a "Pre. Feed" operation is performed to
eliminate any fogged sections at the leading edge.
From the display panel, you can select whether to feed 1 or 3 sheets for this
operation. The length of each sheet is 500 mm, so if you perform a 3-sheet
preliminary feed, 1500 mm of plate will be cut, fed and disposed of.
If there are still darkened or fogged areas on the plate, perform another
preliminary feed.
6.4 Image Data menu
The SDP-Eco 1630 III incorporates a hard disk drive buffer to avoid idle time
due to differences in calculation speed between itself and the host, and to
enable quick re-exposure after an exposure was interrupted (e.g., if you use
the stop key or the plate ends).
Data written in the hard disk drive can be exposed or erased in the local mode.
Select the "Exposure" command to expose the data and the "Clear" command
to erase it.
6.5 Mode menu
In this menu, you can operate the punch (option), select a dryer level, and set
the buzzer response for different key operations.
Set the punch to ON to punch plates before image exposure or set it to OFF if
punching is not necessary.
If the machine does not contain a punch unit, the "Un-mounted" message
appears.
• Punch specifications
Two types of punch unit options can be set: the DS punch (for alternately
positionable punch) and the BELL punch.
The distance between punch holes is fixed, so it is impossible to change the
distance depending on the plate width.
[DS punch] [BELL punch]
Note
- 44 -
220
Leading side
Leading side
386.5
Cut line
Dedicated for 335mm width plates
12 x 16
10 x 16
5 x 8
φ 5