Motorola SSETM 5000 - Manual (Page 89)

6881094C12-A November 11, 2004
Disassembly/Reassembly Procedures: Disassembly/Reassembly Procedures for Accessories 7-7
NOTE: The Motorola-approved battery shipped with the SSE 5000 radio is uncharged. Prior to using
a new battery, charge it for a minimum of 16 hours to ensure optimum capacity and
performance.
7.4.2.1 Attach the Battery
1. With the radio turned off, align the baseplate on the bottom of the radio with the groove on the
top of the battery.
2. Slide the battery toward the latch until it clicks into place.
Figure 7-3. Attaching/Removing the Battery
7.4.2.2 Remove the Battery
With the radio turned off, slide the battery latch up and hold it while sliding the battery away from the
latch.
7.4.3 Belt Clip
This section explains how to attach and remove the belt clip.
7.4.3.1 Attach the Belt Clip
1. With the battery removed, remove the baseplate assembly from the housing assembly
(complete up to Step 5. in Section 7.6.4: “Disassemble the Housing Baseplate” on page 7-
14 ).
2. Hook the top of the belt clip into the slot near the top of the radio in the back.
3. Press the bottom of the belt clip into the slot near the base of the radio until it is pressed firmly
into place.
If the radio is programmed for volatile-key retention,
encryption keys will be retained for approximately 30 seconds
after battery removal.
!
C a u t i o n
BATTERY
LATCH
REMOVE
ATTACH
BATTERY
BASEPLATE