Motorola SSETM 5000 - Manual (Page 92)

November 11, 2004 6881094C12-A
7-10 Disassembly/Reassembly Procedures: Disassembly/Reassembly Procedures for Radio Knobs
7.4.5 Universal Connector Dust Cover
This section explains how to remove and attach the dust cover for the universal connector.
7.4.5.1 Remove the Universal Connector Dust Cover
1. Use a Phillips-head screwdriver to unscrew the screw at the top of the dust cover.
2. Pull the dust cover away and up until it is separated from the radio.
7.4.5.2 Attach the Universal Connector Dust Cover
1. Hook the bottom of the dust cover into the slot on the left rear of the radio, just below the
accessory connector.
2. Align the screw on the dust cover with the hole on the radio, behind the antenna connector.
3. Use a Phillips-head screwdriver to screw the dust cover firmly into place.
Figure 7-7. Attaching the Universal Connector Dust Cover
7.5 Disassembly/Reassembly Procedures for Radio Knobs
NOTE: Numbers in parentheses ( ) refer to item numbers in Figure 7-1 on page 7-3 and Table 7-1 on
page 7-4 .
Table 7-2. Tools Used for Disassembly/Reassembly
When the universal connector is not in use, keep it covered
with the dust cover.
Tool Comment Part No.
ROTO-TORQ Tool Adjustable torque driver RSX4043_
Phillips Head Star Bit Used for attaching/detaching power contact screws. 6680321B79
Channel and Volume Switch
Spanner Nut Bit Used for attaching/detaching volume control and channel
select switch spanner nuts. 6680370B88
Antenna Spanner Nut Bit Used for attaching/detaching antenna spanner nuts. 6680371B34
T-10 Torx Bit Used for attaching/detaching radio bolts. 6680387A74
!
C a u t i o n
SCREW
DUST
COVER
SLOT
TAB
CONNECTOR
THREADED
HOLE