Section 5—wheelchair operation, Operating the wheelchair, Turning the power on/off – Invacare TDX SP User Manual
Page 35: Using the joystick to drive the wheelchair
SECTION 5—WHEELCHAIR OPERATION
35
SECTION 5—WHEELCHAIR
OPERATION
ƽ WARNING
After ANY adjustments, repair or service and before use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
Set-up of the Electronic Control Unit is to be performed only by a qualified techni-
cian. The final adjustments of the controller may affect other activities of the wheel-
chair. Damage to the equipment could occur under these circumstances.
Operating the Wheelchair
Turning the Power On/Off
NOTE: For this procedure, refer to FIGURE 5.1.
1. To turn the power On, perform one of the following steps:
2. Turning the power Off can be achieved by performing one of the following steps:
FIGURE 5.1 Turning the Power On/Off
Using the Joystick to Drive the Wheelchair
NOTE: For this procedure, refer to FIGURE 5.2 on page 36.
The joystick is located on the joystick housing and provides smooth control of speed and
direction. It is equipped with 360 degrees of mobility for ease of operation. The joystick is
spring‐loaded, and automatically returns to the upright (neutral) position when released.
Pushing the joystick in a given direction causes the wheelchair to move in that direction.
JOYSTICK
ACTION
MPJ+
Move the On/Off switch Forward to the On position.
SPJ+
Press the On/Off button.
JOYSTICK
ACTION
MPJ+
Move the On/Off switch Back to the Off position.
SPJ+
Press the On/Off button.
MPJ+ Joystick
On/Off
Switch
SPJ+ Joysticks
On/Off
Button