About transport ready packages, Compliance information – Invacare TDX SP User Manual

Page 65

Advertising
background image

SECTION 11—TRANSPORT READY PACKAGE (TRRO)

Part No 1143190

65

TDX™ SP

ƽ WARNING

Transport ready packages are not retrofittable to existing models and are not field

serviceable.
Only use the transport brackets included with TRRO and TRBKTS for the purposes

described in this manual.
Battery retention brackets MUST be installed at all times. Otherwise, the wheel-

chair will not be WC/19 compliant. Refer to Removing/Installing the Batteries

From/Into the Wheelchair on page 57.

About Transport Ready Packages

TRRO includes four factory‐installed transport brackets and a wheelchair anchored 
pelvic belt. TRRO has been crash‐tested in accordance with ANSI/RESNA WC Vol 1 
Section 19 Frontal Impact Test requirements for wheelchairs with a 168 lb crash dummy, 
which corresponds to a person with a weight of 114 to 209 lbs.

TRBKTS includes four factory‐installed wheelchair transport brackets. TRBKTS has not 
been crash‐tested in accordance with WC 19. Use these transport brackets only to secure 
an unoccupied wheelchair during transport.

As of this date, the Department of Transportation has not approved any tie‐down systems 
for transportation of a user while in a wheelchair, in a moving vehicle of any type. It is 
Invacare’s position that users of wheelchairs should be transferred into appropriate 
seating in vehicles for transportation and use be made of the restraints made available by 
the auto industry. Invacare cannot and does not recommend any wheelchair 
transportation systems.

Compliance Information

This wheelchair conforms with the requirements of the ANSI/RESNA WC/Vol. 1 ‐ Section 
19.
NOTE: ANSI = American National Standards Institute, RESNA= Rehabilitation Engineering 
and Assistive Technology Society of North America.

This wheelchair has been dynamically tested in a forward‐facing mode with the specified 
crash test dummy, which corresponds to a person with a weight of 114‐209 pounds, 
restrained by BOTH pelvic and upper‐torso belts in accordance with ANSI/RESNA WC 
Vol 1 Section 19. BOTH pelvic and upper‐torso belts should be used to reduce the 
possibility of head and chest impacts with vehicle components.

Advertising