Adjustable asba seats, Disconnecting/connecting the joysticks, Spj+ joysticks – Invacare TDX SP User Manual
Page 46
SECTION 5—WHEELCHAIR OPERATION
46
Adjustable ASBA Seats
NOTE: For this procedure, refer to
FIGURE 5.10.
1. Turn the adjustment lock lever to
release the joystick mounting tube from
the mounting bracket.
2. Remove the joystick from the wheelchair.
3. Remove the three hex screws that
secure both halves of the mounting
bracket to the arm tube.
4. Reposition mounting bracket on
opposite arm tube ensuring the
threaded plate of the mounting bracket
is on the inside of the arm tube as
shown in FIGURE 5.10.
FIGURE 5.10 Repositioning Joystick -
5. Using the three hex mounting screws and washers, secure both halves of the mounting
bracket to the arm tube.
6. Slide the joystick mounting tube through the mounting bracket to the desired position.
7. Turn the adjustment lock lever to secure the joystick mounting tube into the mounting
bracket.
Disconnecting/Connecting the Joysticks
NOTE: For this procedure, refer to FIGURE 5.11 on page 47.
NOTE: The joystick connector is located at the rear of the seat frame.
SPJ+ Joysticks
Disconnecting
1. Loosen the thumb screws on the joystick connector.
2. Disconnect the joystick connector from the controller connector.
Connecting
1. Align the joystick connector with the controller connector.
2. Secure the joystick connector to the controller connector using the thumb screws on
the controller connector.
Washers
Hex Mounting
Screws
Mounting
Bracket
Adjustment
Lock Lever
Joystick Mounting Tube
Mounting Bracket
(Threaded Plate)
Arm Tube
NOTE:
Joystick
not shown.