On/off button, Speedometer – Invacare TDX SP User Manual
Page 37
SECTION 5—WHEELCHAIR OPERATION
37
SPJ+, MK6i™ SPJ+ w/PSS and MK6i SPJ+ w/ACC
Joystick Switches and Indicators
NOTE: For the following information, refer to FIGURE 5.3.
FIGURE 5.3 SPJ+, MK6i™ SPJ+ w/PSS and MK6i SPJ+ w/ACC Joystick Switches and Indicators
On/Off Button
This button is located at the front of the joystick housing. It is used to turn the wheelchair
On and Off, to remove the joystick from sleep mode (if programmed) and to lock or
unlock the joystick (if programmed).
Speedometer
The speedometer is used to show the maximum speed. The right‐most LED indicates
current maximum speed setting. The bottom left GREEN LED flashes to indicate that the
joystick is in speed limit mode. Speed limit mode limits the drive speed to a pre‐
programmed value, typically when the seat has been elevated and the wheelchair is
required to drive at 20% speed.
On/Off
Button
DETAIL “A” -
FRONT VIEW
Charger/
Programming
Input
Speedometer
Joystick
GREEN
LED
Information
Gauge Display
Service Indicator
Decrease
Speed Button
(Tortoise)
Increase
Speed Button
(Hare)
Mode Button*
Additional Input
for Powered
Seating Switch
*NOTE: The mode button is only
present on SPJ+ w/ACC joystick.
Not
Active