Ƽ warning – Invacare TDX SP User Manual
Page 60
SECTION 10—BATTERIES
60
5. Slide the battery tray into the wheelchair (FIGURE 10.3).
6. Install the battery door and rear shroud. Refer to Installing the Front Shroud/Battery
Retention Bracket and Rear Shroud on page 60.
FIGURE 10.4 Installing Batteries into Wheelchair
Installing the Front Shroud/Battery Retention Bracket and Rear Shroud
ƽ WARNING
Wheelchairs with TRRO or TRBKTS Only - Battery retention brackets MUST be
installed at all times. Otherwise, the wheelchair will not be WC/19 compliant.
After installing front shroud, ensure that the mounting screws on the front shroud/
battery retention bracket are fully engaged into the battery box.
NOTE: For this procedure, refer to FIGURE 10.2 on page 58.
1. Reinstall the front shroud/battery retention bracket onto front of wheelchair frame.
2. Install two mounting screws on the sides of the front shroud/battery retention bracket.
ƽ WARNING
When installing batteries, ensure battery connector is securely engaged to the con-
troller connector - otherwise serious personal injury may result.
3. Wheelchairs with Footboards Only: Using the mounting screw and washer, secure the
footboard support to the wheelchair frame.
4. Connect the controller to the batteries at the rear of the wheelchair.
DETAIL “A”
DETAIL “B”
DETAIL “C”
Battery with Battery
Connector Bracket
Front of the Battery Tray
Rear of the Battery Tray
Battery Stop
Connect Front
Battery to
Rear Battery
HERE
Rear Battery
Front
Battery
Battery
Straps
NOTE: 22NF Batteries
shown.