Repositioning joystick, Van seats – Invacare TDX SP User Manual
Page 45
SECTION 5—WHEELCHAIR OPERATION
45
Repositioning Joystick
Van Seats
NOTE: For this procedure, refer to FIGURE 5.9.
NOTE: Take note of position and orientation of mounting hardware for reinstalling the joystick
assembly.
1. Turn the adjustment lock lever to release the joystick mounting tube from the
mounting bracket.
2. Remove the joystick mounting tube from the wheelchair.
3. Remove the three hex mounting screws, bushings and locknuts that secure the
mounting bracket to the three mounting holes on the armrest plate.
NOTE: The mounting bracket is mounted to the inside of the armrest plate.
4. Reposition the mounting bracket on the opposite armrest plate.
5. Using the three hex mounting screws, bushings and locknuts secure the mounting
bracket to the three mounting holes of the armrest plate.
6. If necessary, perform the following to reposition the adjustment lock:
A. Slide the adjustment lock from the mounting bracket.
B. Rotate adjustment lock 180° and slide adjustment lock over the opposite end of the
mounting bracket.
7. Slide joystick mounting tube through the mounting bracket to the desired position
and secure adjustment lock to tube by turning lever on adjustment lock.
FIGURE 5.9 Repositioning Joystick - Van Seats
Locknuts
Bushings
Armrest Plate
Mounting Bracket
Hex Mounting Screws
Adjustment Lock Lever
Joystick Mounting Tube
NOTE: Joystick
not shown.