Juniper Networks ERX Hardware 8 - Manual (Page 69)

Installing Modules
Verifying the Installation
To verify that the installation is complete:
1. After you have cabled the system for power, as described in “Cabling ERX
Routers” on page 53, turn on the power switches.
The system reboots.
2. Issue the show redundancy command, and verify that the display shows
the redundancy hardware.
Configuring Line Module Redundancy
For information about configuring line module redundancy, see JUNOSe System
Basics Configuration Guide, Chapter 6, Managing Modules.
The Next Step
After you install the modules, you can connect cables to the system.
See “Cabling ERX Routers” on page 53.
The Next Step 51