Juniper Networks ERX Hardware 8 - Manual (Page 99)

Accessing ERX Routers
2. Enter the configure command.
host1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
host1(config)#
The system is now in Global Configuration mode.
3. Enter the line command.
host1(config)#line vty 0 4
host1(config-line)#
The system is now in Line Configuration mode.
4. Disable the password.
host1(config-line)#no login
NOTE: In this example, you disabled the password requirement, but you can choose
to set a password instead. See JUNOSe System Basics Configuration Guide, Chapter 8,
Passwords and Security for information on setting a password.
5. Run Telnet from a host on the same Ethernet network as the system.
6. Enter the IP address of the system to open the Telnet session.
The User Exec prompt appears when the Telnet session to the system is
established.
host1>
7. Enter the enable command.
host1>enable
host1#
The system is now in Privileged Exec mode.
8. Enter the configure command.
host1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
host1(config)#
The system is now in Global Configuration mode, from which you can
configure the system. See JUNOSe System Basics Configuration Guide, Chapter 2,
Command-Line Interface.
Telnet Setup 81